MAKO Handheld Portable

MAKO Handheld – Portable UV Machine

Like the entire line of HID Ultraviolet equipment, the MAKO is equipped withInstant Start Lighting technology. Unique to HID Ultraviolet, this allows for the lamp to be turned on only when you need to cure. There is no need to wait for the lamp to warm up, or cool down before you can use the machine again. Just position the MAKO over the surface you intend to cure, press the button, and the lamp will start. This reduces the chance of unintended exposure to UV light, and eliminates the need for mechanical shutters.

The MAKO handheld portable UV comes packaged in a crush proof case, making it impervious to wear and tear that it may endure going to and from job sites.  The case comes with two sturdy handles, one extension handle, and wheels for easy transport.  When not in use, place the MAKO in the custom thermoformed holster with a built in heat sink.

The UV lamp head has a modified elliptical reflector that accommodates both focused curing as well as flood curing.  Continuous wave xenon lamps produce 25 – 30% more energy than a stardard mercury and is low dose mercury at 10 mg or less, compared to 250 mg found in most other systems.

Like the entire line of HID UV equipment, the MAKO is made with the most advanced features and technology in order to offer safe and reliable performance that sets the standard for onsite UV curing.  A spring loaded trigger requires operator input in order to run the lamp head.  A safety (emergency stop) button is mounted on the lamp head for easy access.  Thermal sensors in the head and power pack monitor the operating temperature of the system.


The MAKO is equipped with an automatic range finder.  Built in ultrasonic sensors can tell when the machine approaches the surface to be cured and will allow the light to operate only when near the substrate.  If the lamp head is raised too far above the surface, it will automatically shut off in order to prevent Ultra-Violet exposure.  The machine has three LEDs that tell the operator if the machine is too close, in focus, or in flood mode in relation to the surface being cured.

MAKO Cure Path Power Input Weight
(Hand Held)
Weight
(With Case)
Size
6-1200 6″ 1200W 120V 60Hz 15A 2 lbs 50 lbs 22″ x 14″ x 9″
6-1200 15.2 cm 1200W 230V 50Hz 10A 0.9 kg 26.3 kg 55.9 x 35.6 x 22.9 cm

Download MAKO Handheld Product Sheet
Download MAKO Handheld Manual